Administering the Injection
How to Give a Subcutaneous Injection
Before the Injection
Some medications such as Semaglutide and Tirzepatide must be injected. These medications come with a kit and a device to inject the medication.
Some patients however prefer not to use the kit but to do the injection themselves; much like an insulin injection would be done. If your medication is refrigerated, remove the vials from the refrigerator 30 minutes before administration so it can reach room temperature. Select a clean, dry work area.
Gather your supplies:
1. medication
2. sterile disposable needles and syringes
3. alcohol pads or cotton balls
4. puncture proof disposable container
5. bandaids*
6. WASH hands well before preparing your medication
*HINT The container can be a coffee can or leak-proof, closable milk jug. Find out the proper way to dispose of biological waste in your area.
Preparing the Injection
Your Symbios Health Connect provider will instruct you on preparing your particular dose of medication.
Giving Yourself the Injection
Select your injection site. This must be an area that has a layer of fat between the skin and the muscle. This is called subcutaneous. The following parts of your body have subcutaneous layers:
-
outer surface of the upper arm
-
top of thighs
-
buttocks
-
abdomen, except the navel or waistline
-
If you are very thin do not use the abdomen as an injection site.
-
Do not use the same site for injections each time.
-
Rotate your injection sites in a regular pattern. You should be at least 1 ½ inches away from the last injection site. Jot down on your calendar where you gave you last shot. This will help prevent giving the shot in the same place too soon.
-
Select a site and cleanse the area (about 2 inches) with a fresh alcohol pad, or cotton ball soaked in alcohol.
-
Wait for the site to dry.
-
Remove the needle cap.
-
Pinch a 2-inch fold of skin between your thumb and index finger.
-
Hold the syringe the way you would a pencil or dart. Insert the needle at a 45 to 90 degree angle to the pinched-up skin. The needle should be completely covered by skin. If you do this quickly, you will feel very little discomfort.
-
Slowly push the plunger to inject the medication. Press the plunger all the way down.
-
Remove the needle from the skin and gently hold an alcohol pad on the injection site. Do not rub.
-
If there is bleeding, apply a bandage.
-
Immediately put the syringe and needle into the disposal container